FED-X Splashback Top 1795 mm 3 Door 600 mm Underbench XUB63-WBB

The XUB63-WBB is a splashback top panel, 1795 mm wide and 600 mm deep, for FED-X 3-door 600 mm underbench units. It replaces the flat top with one carrying an upstand along the back edge, so splash from the bench behind runs down onto the top instead of behind the cabinet - which is the one place nobody can clean without pulling the unit out. It suits XUB6C18S3V and XUB6F18S3V. The upstand height is not confirmed - read the FAQ before you set a clearance.

Why operators choose the XUB63-WBB

• 1795 x 600 mm - matched to the 3-door 600 mm cabinet - a model-specific panel, not a sheet cut to fit on site
• Rear upstand - contains splash and spill at the back of the bench rather than letting it run down between the cabinet and the wall
• Suits XUB6C18S3V and XUB6F18S3V - the models named by the manufacturer for this panel
• Stainless working surface - the top itself stays a wipe-down bench
• Factory-matched fit - no site fabrication, and no sealant bead doing the job of a panel

Specifications

Venue suitability

This suits any FED-X underbench installation standing against a wall or behind a working bench, where splash would otherwise run down the back of the cabinet. Specify it with the cabinet where you can - retrofitting means lifting the existing top.

See the full refrigeration accessories range.

Installation & delivery

Replaces the standard flat top on the matching cabinet. Confirm your cabinet model against the suits list (XUB6C18S3V and XUB6F18S3V) before ordering, because the panels are specific to width, depth and door count. Confirm the upstand height with us before setting clearance to a shelf or bench above - our supplier records conflicting figures and we will not publish one until they confirm.

Warranty terms vary by product - see our warranty information page for full details.

Frequently asked questions

Q: Why is the upstand height not stated?

Because there are three different figures on record and none of them agrees. Our supplier's data feed lists 140 mm in its height column, the same feed's product description says 100 mm, and our own stored specification says 140 mm. Rather than publish a number you might set a shelf height from, we have left it out and asked the supplier to confirm. Contact us and we will chase it for you.

Q: Which cabinets does this fit?

XUB6C18S3V and XUB6F18S3V. The panels are specific to the cabinet width, depth and door count, so check your model rather than ordering on width alone.

Q: What does a splashback top actually change?

It adds an upstand along the rear edge of the top. Without one, anything spilled at the back of the bench runs down between the cabinet and the wall, where it cannot be cleaned without moving the unit. With one, the spill stays on the top where it can be wiped off.

Q: Can it be retrofitted to a cabinet already installed?

It replaces the existing top, so yes - but it means lifting the current top and usually pulling the unit out from the wall. Far easier to specify it with the cabinet.

Q: What warranty applies?

None is recorded against this panel by the supplier. Terms vary by product - see our warranty information page, and ask us if you need it confirmed before ordering.